[ECVcrawltoy711]

Originally Posted by jboatman333

.

1st ? - Do i disconnect the drive shaft, if so how does it come apart?

Yes, is it 4wd?

2nd? - Do you think i will need any specialty tools that i might not have?

Long extention to get the top t tranny bolts, prolly an impact gun to get the fly wheel off and a pilot being puller

3rd? - Once i have unbolted the trans from the engine, and removed the tranny mounts, will there be anything else i need to remove in order to pull the tranny.

shifters and a few wires

4th? - Once the tranny is free, and i plan on using a jack to lower it down, Should i watch out for pieces of the trans falling out or will it be pretty self contained.

Should all be good to go

5th? - Is there any type of lubrication needed for the clutch that has to filled once the new one is in.

Other then the fluid for the hudro clutch no. also check the rear main also if its leakin replace it

DRew