Quote:
|
Originally Posted by TealZ00
I used Friction Master cermaic pads so they arent cheap ones....i just put them on the front and i havent replaced the rotors...u think it might be the rotors?
|
You shouldn't have done that. If your rotors are cut or warped you just wasted money on new pads because the pads will start shaspaing themselves. Never replace pads without at least cutting. If they're too thin to cut, replace them. Gads they're cheap. Also did you use anti-squeal on the back of the pads? Did you check the condition of your retention clips? If they were corroded did you clean them up or replace them??