Hello,
A quick post to continue the fabia story !
I started to modify the dashboard on its right side, because it was too narrow to receive properly the tripmaster decal.
I first primed in black the part.
then I cut the right side at the good size and put the sintofer resin under the part to make less narrow.
I have to wait 24 hours beforer trimming it again, hoping I won't trim too much and have to start a new resin operation !
photo is not very good to see this step, but the grey part under the dashborad is the sintofer resin to be cutted and trimmed at the right size and form, the light part is the original part primed I trimmed a first time to prepare the part, and all the black is the dashboard original part !
I hope to finish the dashboard this evening.
While I am going on on mine, my brother finished the inside of his model !
here it is:
a photo to come.