Quote:
|
Originally Posted by sjelic
I think you decided right, You avoided few things that would interfier with roll cage in folowing steps and those are seats and those beams that connect rear wheel wels with that center part of roll cage, I have put this middle part on place Reji wanted but I cuted the lower part and glued it under different angle to make it go further back, that saved position of seats but did not solve those beams so I also adjusted those and cuted groves in that panel on the chasis to make some space for the beams. One more thing to take care if you are not carefull (constantly trying to fit the body on the chasis with every new step) you will have problem to fit the body at the end, so be carefull.
I am with you  , I am sure it will come out far better then mine. |
Thank you Sasa for your wise advices.
yes, that's right there is a litlle problem to fit body, I noticed it too, but I think I've found where the problem comes from:
It seems that the rear panel part supporting spare wheel comes to high on its side and blocks the door panel...
I have to verify this but I think this is the fitting problem key.
I never used to glue my body model, but I am wondering if I wouldn't do it for this one...
