|
No its very simple
!Adjusting ignition timing without a consult:
Turn Off engine and disconnect throttle position sensor harness connector. (TPS)
Start engine
Rev engine (2,000 – 3,000) 2 or 3 times under no-load, then run engine at idle speed
Check ignition timing with a timing light
Manual transmission 15 +/- 2° BTDC
Auto transmission on 95+ is the same spec, check the specs below for other models
Adjust ignition timing to the specified value by turning distributor after loosening bolts which secure distributor. Stop engine, and tighten the distributor (do not move it!). Restart engine and make sure the timing has not moved.
17 and 91 fuel
__________________
1998 PRIMERA GX 10.1 CR Chile.
|