[talonx]

oh, 1999, 2 dr, 4.3 L Auto.

This morning to asses the ECM I disconnected
the cam position sensor. No check engine light when started.

I disconnected the MAF sensor. The SES light did come on.

I still think the PCM may not be adjusting the engine right.
IS there something in the trany? But, when I leave it in 1st
or reverse I get the same problem. Bogs down and wont rev past
1000/1500 rpm.

I'm going to take out the ECM and see if anything visually blew on the
board.

I there anything else I should be looking for?