[Tyrone Biggums]

you'll need a lot more parts to complete. i have a few of the main parts you'll need for sale.

Turbonetics- T3/T4...this is the same turbo used in the AAI and FIAS/Maxrev
1st gen turbo manifold, BOV, injectors/rail, SMIC
you can get all these for cheaper than the one turbo- PM me

In a tight nutshell- you will need a spacer to go between the manifold and exhaust ports/head. otherwise, you will not clear the starter.

after clearing the starter, you A/C lines will be in the way. either bend them some how, or remove your A/C. and since its a BIG 16G, you will most likely have to take out the A/C.

then you will have to Fab a midpipe, intercooler pipes, etc....

this is barely the tip of the iceberg. the list goes on. we havent even gotten into fuel management, wiring....... for our car, custom turbo kits are possible, but not as easy and strait foward as the kit. i just purchased a kit from donny (AAI/APP) and it is being built as you read this. install is a simple bolt on job, no second guessing.