[horseshoe]

I have a bad rear bearing in my 99 Intrigue. I have purchased a new rear hub assembly from Autozone, but I have a couple of questions about installation.
I have removed the caliper, the 4 hub to knuclkle bolts, the antilock connector and the 2 small screws that mount from the bottom back and hold the emergency brake assembly in place. The hub won't budge.

Question 1. Have I missed anything that may still be holding the hub in place.

Question 2. If not, how do you get it to seperate. My guess is I will need a flange puller and slide hammer combo. Another possiblilty is several bolts about an inch and half longer than the hub mounting bolts. I would screw them in and then back them out against the hub using a wrench.

If someone has knows the best way to procede, I could use the advise as my car is up on jack stands at the moment.