|
-I hope I now solved the Drl/low beam problems.There are 4 taped wire splices under the washer fluid bottle.One of the wires was broken.I untaped and cut all 4 joints and resoldered the joints and used heat shrink tubing over the joint.The wire splices were quite corroded.I had to splice in a 4" length of new wire at 2 of the joints.Do one joint at a time to avoid crossing the wires.I wrapped everything with $4/roll good quality electrical tape also.On the 2001 ,remove the 2 bolts to remove the head light assembly. To get at the washer bottle take off the front plastic inner fender liner.You will then see 2 bolts that hold the washer bottle.There is also a ground bolt under the battery tray that is very hard to get at that must be removed to allow moving the wiring to get access to the splices.There is also 1 crimped splice behind the right headlight which looked ok but I also resoldered and taped it.Washer fluid is corrosive and spills will damage the wires.The total job took about 4.5 hours.
|