|
Re: New thread
Old-time tricks available~~~~~~~~~
1] you can direct battery-jump any motor, once it unplugged off factory harness to see if if it runs.
2] ya can use jumper-cables off the batt. terminals to send power out to motor terminals.
3] Get some 14 or 16 guage wires to clamp to feed-end of jupmper-cables. WATCH OUT, don't cross the jumper cable ends together, lol.
4] Use the 14\16 gauge wires to touch the motor terminals, but again PAY ATTENTION.
It sort of like this, hook the + and - terminals of jumper cables to battery appropriate terminals. Then ya clamp a lead of 14/16 gauge wire, to each of the free jumper-cable terminals, and those 14/16 wires can become your probes to the motor terminals. Watch out for the free-jumper cable ends connecting.
|