Quote:
|
Originally Posted by vjp64
Engine runs without MAF sensor connected.
Soon as I connect it the engine dies out shortly after.
I will pick one up monday and swap it out.
I noticed the screws on that thing are different than usual. What type of bit do I need for this thing?
Does the engine need reprograming after in stalling a new MAF sensor?
|
Thats good news. The screws are Torx safety types. The tool is available at Autozone, Sears, etc. It's like an allen key but the tip inside is hollow.
No re-programming or resetting ECU/PCM required. Once hooked up take it for a good spin and it will re-learn over the next few drive cycles.
Good luck!