[mdhbhouse]

Same guy that posted this message so not an official 'how to' but I did get it replaced. If I could have gotten the passenger side panel off I'm sure this would have been eaiser but I couldn't get it. Even if I had been able to remove the panel there are I think seven screws that hold the motor in place and those screws are very tought to get at. I ended up getting a flexible shart that I could attach a 5/16" socket (I think) on to be able to get at the screws at the back. This has got to be the most frustrating parts I've ever had to replace (just not enough room for me to get at it properly). I did end up removing a bolt on the passenger side wall that kind of holds the main metal housing that the panels screw into in place. That gave me just enough room to wiggle the motor out.
So suffice to say it can be done but there may be a better way to get access to it.
As an fyi, I picked up a universal motor which didn't some with any clip on the end so I had to cut the wires and use some crimp on connectors to make it work. So far it works and I have heat again so after a far bit of cursing I'm happy and (for now) I'm done with it.

If you want more detailed steps I can post them.