[phuz]

well, on thursday i am going to pull off the whole plenom and replace the fuel press. regulator. i am also going to replace the cap and rotor. i had this problem on the original motor and replaced the fuel press. regulator and it worked fine. i just dont understand how the engine ran fine before i took it back to have the bearings replaced and now it misfires. it shouldnt be any different if they didnt touch anything up top. and i highly DOUBT that the gas got gummed up causing a problem. if anyone can think of anything else that COULD have caused this phenomenom, let me know, otherwise i will post results following the test-drive after i replace these parts. thanks guys!!