Quote:
|
Originally Posted by Hog Caller
I checked the TDC and the Crank sensors per the service manual. They both have the proper resistance, 900 ohms. I verified continuity and no ground of all wires to the ECU.
|
ok so you have continuity. now check if they are getting power when you turn key on engine off. if ok then check the signal wire (blue wire on the negative side of the ignition coil) and see if youre getting any fluctuating voltage when you crank your engine. this is the signal needed by your ignition coil to fires up your sparkplugs.
3 basic things needed to run an engine: fuel, compression and spark. if one of them is missing, your engine will not run.
my question is...what happened before your engine quit running? did your engine just quit running by itself or did you do any repair and mess up something?