View Single Post
  #4  
Old 02-16-2005, 07:00 AM
scott flynn scott flynn is offline
AF Newbie
Thread starter
 
Join Date: Feb 2005
Posts: 5
Thanks: 0
Thanked 0 Times in 0 Posts
are there any wires I could have missed?? I plugged in the distributor, coil(there are two sockets that plug into it), oil pressure switch for the fuel pump that is on the pass. side of the block, the three plug ins on the top of the manifold on or near the throttle body, one plug in on the thermostat housing, one on the pass. side of the TBI unit, mass air flow sensor is plugged in, the two sockets that go the the trans are plugged in, and the ground wires are grounded. The is a larger gauge black one, a tan wire with a black/white wire with the same end, this should be for the fuel pump, a small tan wire and the ground strap to the firewall. Those are all grounded on the back head stud. These are all of the connections that I took off. I also connected the wires for the fuel injector. The starter and alt. are all hooked up as well. It runs fine if you dump gas down the throttle body, but the fuel pump won't kick on when the key is turned. The realy is getting power from the orange hot wire that runs from the battery, but it is not getting juice from the green/white wire that comes from the ECM.
Reply With Quote