[pntcbonnesse]

ok well I was searching the forum for ya and I did find directions that are similar to just grounding pin 4 to pin 8 but there is a little more work involved. I guess that im glad that I have to only jump 4 to 8 haha its easy... ANYWAYS these instructions I found posted by another member it is for a 97 Bonneville... dont know if it will work but hey its worth a shot right??? ok well here goes


first make sure you have the correct keyless remote check with your local dealer then if correct do these next 6 steps before starting procedure get a fused jumper wire #1 turn ignition switch off #2 using a fused jumper jump terminal 8 blk/wht to terminal 4 blk on the data link connector close all doors #3 turn ignition switch on door locks cycle #4 press and hold lock and unlock buttons on the remote hold for about 30 seconds or so locks will cycle again #5 to program another remote repeat step four but during this whole process DO NOT TURN KEY SWITCH OFF #6 disconnect your jumper wire from the data link connector now at this point it is okay to turn ignition switch off but not until this point

Please let me know if this one works!!! Thanks!!! oh and im sure that you already checked the obvious which would be the batteried dead haha. This is the only thread that I found that is closest to a 96 bonneville and not a 95 bonneville... so give it a try and email me or reply back to the thread and let me kno!!! Good luck!