|
All you need to remember is to torque the hub nut back to 180ft pounds. Pretty simple change. Remove the hub nut. Tap the CV joint back a bit to loosen it up, remove the 3 18mm bolts holding the hub. Disconnect the abs sensor wire, remove the 2 clips holding the ABS sensor wire, pull the hub, install in reverse. Will take about 40 pins per side on the average
__________________
 
95 s10 Blazer, EGR Mod, ZQ8 Steering box mod, 99 Center console shifter mod and more... See everything at www.pghconsulting.net/teal
|