Hi All
My current project is the Revelegawa Lancia O37 and in a fit of enthusiasm just after Christmas I decided I would add a lot of extra detail, coolant header tanks, fuel tanks, front space frame, wiring and plumbing etc. I used my trusty razor saw to remove the rear deck and the small opening on the 'bonnet' I decided to leave the doors in place.
Problem is when I made up the hinges to re attach the rear deck they need so much offset (to allow the deck to swing up) that they cut into the rear bulkhead window ( and look a bit agricultural).
The original car had plain hinges surface mounted on the roof but recreating these in 1/24?????? well you know what I mean. Any body out there solved this problem in past life?
Oh and by the way, I already know I shouldn't have removed the deck in the first place?