[termiflyer]

Hi all. I'm not sure if this is the best place to post, but I thought you might be most knowledgeable on this type of thing.

I've got a pinhole leak in an automatic transmission fluid cooling line. I'm hoping to avoid replacing the lines since they wind all over from in front of the radiator all the way back to the tranny. I would also like to avoid cutting a section out of the line, since the spot where the leak is is in the worst possbile spot to get at.

So, I'm hoping something like JB Weld will do the trick. I did a bit of looking around, and JB weld, RTV silicone sealant, quicksteel, all-metal all came up.

As you might expect, I am wondering if you can recommend a solution out of these, or anything else that I didn't mention.

Thanks in advance.