View Single Post
Old 01-19-2005, 05:28 PM   #11
Gerrick
AF Newbie
Thread starter
 
Join Date: Jan 2005
Location: Houston, Texas
Posts: 11
Thanks: 0
Thanked 0 Times in 0 Posts
Re: 98 4Runner replaced starter/ignition coils/wireset

OK!!! Checked the battery with the ignition in the 'on' position. Not 'start' cuz it won't remain in that place after attempting to start.(I didn't know that) Anyways, the battery then measured 12.25V. I checked the posts, then the clamps, 12.25V. I then checked the negative(right i assume) post to the large wire leading under the starter, 12.25V. Then I checked the positive(left) post to the small wire with a insertable clamp on the end of it, NOTHING. Switched from that clamp to the right and nothing as well. Is this bad?
Also, I thought 12.25 wasn't enough anyway. OK, you brought me this far.....
Gerrick is offline   Reply With Quote