[FFHP.net]

Here's a run down:

Engine threw a rod so we rebuilt it (professionally)
Engine now runs like a charm.
However, it's overheating.

All hoses are properly located
Coolent is good
Thermostat and water pump have been replaced with new
Top radiator hose fills with hot air as the engine overheats
Lower hose doesn't get hot at all
Heater hoses get no heat, and thus no warm air into car

We're tired of the car sitting on the lift, but we're doing the job for a friend and need to get it done.

Anyone have any suggestions we could try? I've searched through the forums enough and not found anything that's helped. Thanks for any help you can provide.

(Oh, one more thing, the engine was from a 95 Del Sol, DOHC VTEC if that is important)

Andy