|
Re: need help installing a mbc on my 2g t25
I can tell you how to install a homemade/JoeP boost controller....I wouldn't think that the xs would be any different.
Before I get to that what did you mean by this statement "it should have been putting out 1 psi"????
You need to remove the lines running to the BCS, but leave the electrical harness plugged in. The side of the MBC with the ball should be run to a T in the line coming off the BOV. The other side should be run to the WG actuator. Then all you have to do is set the MBC. Everyone recommends to start with the MBC backed our all the way and make a pull. Then stop, pop the hood and screw it in all little....repeat. Also, if you are using the stock BOV you may want to consider upgrading, it leaks. Enjoy.
__________________
1997 Spyder GS-T
5-Speed
EVO III 16g, DSMLink, Walboro 190 lph Fuel Pump, FIC 650cc injectors, CoolingMist 150psi Methanol Injection, Greddy EVO 2 Cat Back, 2.5" Extreme DP, 2.5" Extreme Hi-Flow Cat, Injen intake, HyperDrive C1 Street Disk & PP, HyperDrive Lightweight Flywheel, 1g BOV, RRE UICP, Home Depot MBC, AEM UEGO WBO2, Brembo Slotted rotors, Akebono Ceramic Pads
|