|
Re: Air intake Manifold help
Quote:
|
Originally Posted by Pimpdady753
ok im going to be getting a new bottom and top air intake manifold.
is this one any good. http://cgi.ebay.com/ebaymotors/ws/eB...941917496&rd=1
it comes with the top and bottom.. also how hard is it to put one in and take the old one out. and i have a stock hood i wont have to get a new hood will i. some one help me thanks alot. |
It's not that bad just need to take the throttle body and air intake off. Then remove the manifold (simple it's 6 bolts). The bottom is a little bit more, disassemble the fuel rail and lines, remove injectors, and disconnect all hoses then remove (8 bolts). Make sure to get a new grommet-pcv filter, and gaskets. Put some penetrating oil on all the bolts to loosen them up. When I installed my intake manifold 2 bolts in the lower manifold were seized into the heads so I had to have them machined out.
__________________
1988 Mustang 5.0 5spd/CAI,BBK 65mm TB,BBK underdrive pulleys, Flowmaster catback, E303 cam, headers, mass air conversion, Steeda tri ax shifter, 3.73 gears, Trick Flow street intake, 3g 130 Amp Alt.
|