Thanks for the Response,
Well, I adjusted the Rocker Arms per Instruction and using the Finger techniqe to spin while tightening then add 1/2 Turn to it. I dont know though if it made a difference. (Puzzled)
I tried to break the Distributor Lose to no Avail just yet. I sprayed some degreaser down in there (Around the Base) with the cap off and tapped on it a bit. It looked like it was moving a lil but I still couldnt be fore sure. Tried to move it with my hands and Notta.. Wont Budge.. I'll keep working at that..
Whats still puzzling me is the Poping Sound when I pump or hold the Gas while trying to turn the Truck over. The only bad thing is im doing this all myself so I dont have someone to sit in there and do that for me while i kinda watch and listen to see where its coming from.
I did notice while i had the cap of the distributor I was messing with the Rotor and it would Jiggle just a little bit (Small fractions of an Inch). The Ignition was on and each time i kinda jiggled it the one or the Other Injector would spray gas alternating. ... So im guessing my Injectors are working Right. (Or atleast they are puttin gas where it should be)
Im still puzzled at the fact that it wont start... Its killin me here. I go out and mess with it jiggle this tighten that losen this and adjust another. Start to try to turn it over and such and still spin spin wanna start spin wanna start spin wanna start pump the gas pop pop hold the gas pop pop.. Anyone any other Ideas???
Thanks
~WiLL