[ludeguy]

Originally Posted by sprayedlude93

BUMP its cool this post was consoladated but now noone replies to what i need so i am bumping this..

here is aceshigh's post about the swap (with photos) it should answer most of your questions.

http://www.automotiveforums.com/vbulletin/t211027.html

ok cool. I already got the h22 trans with the motor. its not lsd btw. Im just woundering if there would be any gains or loses in the q/t mile.

i doubt it. I used the h23's transmission with the jdm h22 in my lude, because i didn't want to pay for another tranny however. I can rev to limit.

I was woundering if I could use my h23 axles on the h22 motor or do I have to go get h22 Axles? any help would be appreciated. THANKS

you can use the "axles" - i answered that in another thread you posted about the same thing.

I read on here a few months back that the h23 wiring harness was already run for vtec. I even seen the picture someone had on this site showing where the wire was under the hood. I think it was a blue wire. Well, I have a complete h22 swap ready to go in and if i dont have to use the h22 harness i wont.

trust me - you don't want to use another harness - that's way more work then what is needed... use your existing h23's harness. If your car is a 93+ then yes - it is pre-wired for vtec so all you have to do is extend (splice) the wires to their destinations (well documented with photos in aceshigh's doc). if your car is a 92, you are going to have to manually run 2 wires thru the firewall - it's not hard - and is also well documented in acehigh's doc.

if you're wondering why people aren't responding to your post - it's because the questions you are asking are all very well documented on this site, just try a search - it's that function at the top right of the forum - sometimes you have to read to find the information - it sucks - but then again the information is free and you don't have to wait to get it (: