Hi Eggert,
Thanks for your help! I did what you recommended and it works great!
Thanks again!
YukonJen
Quote:
|
Originally Posted by Eggert
Hi YukonJen, it is not a big deal to do. You just take some material off the inside of the connector to accept the 2 ridges of the bulb (instead of just one ridge). The factory projector headlamp has a plug converter harness piece on it.
Here is what I posted some time ago in a thread titled "Yukon and Denali"
Link to the whole thrad:
http://www.automotiveforums.com/vbul...47#post1798547
There is one modification you must make:
Both Denali Hi and Low beams are 9005. The old low beams are 9006. This is not a big deal, but you must make the groove on the light bulb connector wide enough to accept the two ridges from the bulb.
I used a drill and a kitchen knife. Be careful, the plastic is quite soft.
Take care and happy carving. Eggert Johnson  |