|
You're thinking of the passenger side driveshaft, which has the circlip. That side went in just fine, but the driver's side driveshaft doesn't have a circlip so it should just slip right in. What I discovered today was that i'm pretty sure it goes in all the way, but the bearing piece that connects the two half-shafts and bolts up to the engine block, won't line up with the holes and pegs that it sits on. It's only off by about 1-2 mm, but it doesn't want to go any further no matter what I try. Any suggestions on that part? It needs to be bolted there before I can drive it. Once this problem is solved I will finally be done with my automatic to manual conversion, I've been at it for about a month now so any help is really appreciated! Thanks!
|