[93_R/T_TT_Stealth]

i know what your sayin - the plastic moldings where the seat belts go on the side go all the way down to the windshield in the front... 90 - 91 have them -where the seat belt goes up the door from on the bottom an click into the latch an then go up to the side of the car behind the seat. But the ones you have only go half way up from the windshield an will obviously leave you with out molding on the back half where the belt bolts into the side of the car on the top.... i would take both piece an line them up pencil a make alittle extra than what needs to be cut then take a utility knife an skim had the end so it slide under the new pillar pod you want to install - then tech. screw the mold into the metal when you have it in the correct position...

Good Luck
Hope That Helps =)