Quote:
|
Originally Posted by Tim the Toolman
What year is your Aerio? 2002 are not reprogrammable, you will have to have the reciever and remotes replaced..
For '03 Aerio's, use the following procedure..
PROGRAMMING A NEW TRANSMITTER
You can program up to 4 transmitter codes into controller memory. The four codes may be the same or
different. if you try to program a 5th code, the oldest code will be cleared automatically.
1) Confirm that all doors are closed and the ignition key is out of
the ignition cylinder.
2) Open the driver’s door. Insert the ignition key into the ignition
key cylinder and turn ignition switch to ON position within 10
seconds.
3) Turn the ignition switch to OFF position and remove the ignition
key from the ignition key cylinder within 10 seconds.
4) Push and release the driver’s door switch 3 times within 20
seconds.
5) Insert the ignition key into the ignition key cylinder and turn i
ignition switch to ON position within 10seconds.
6) Turn the ignition switch to OFF position and remove the ignition
key from the ignition key cylinder within 10 seconds.
7) Press the “UNLOCK” buttons on the transmitter one time within
20 secionds after step 6. All the doors will lock/unlock to confirm
that this procedure has been properly done. With this process,
the transmitter has been programmed.
8) If you want to program the additional transmitter, repeat the
procedure from step 1 through step 7.
9) Make sure that the keyless entry system properly operates by
operating each transmitter.
Tim
|
Do I re-close the door at anytime. And door switch is the lock switch correct? You said press and release driver's door swtich 3 times. This meaning toggle lock/unlock 3 times or just lock 3 times or unlock 3 times which?