|
Help! ZC problem
i have a 88 ZC motor with pm6 ecu and pm7 chip on the board.
my car is stalling out and dying after running for a few minutes, not just as it gets to temperature a little bit afterwards, you notice a slight hesitation about a minute before it stalls out, if you wait about 3 minutes the car will restart and run another 10 or so and do the same thing. the ECU is flashing code 9 (crank angle sensor) but its done that as long as ive had it, 8 months or so, weve tried reconnecting the wires and that seemed to correct the problem for a week or so and then it happened again. anybody know about this?
|