|
Re: Rearend Rebuild?
its not hard but without proper tools u can damage the bearing during intalation, and it will fail and spead metal throw axle and u will have to do all over, and to set pinion depth may require r&r of pinion and pinion bearing several times to change shims, inless you have a press and bearing remover jigs, yoke removel tool, ft lb torque wrench, inch lb torque wrench, slide hammer and outer bearing adapter, dial indicater, and misc. wrenches and sockets i would recomend having in done somewhere
__________________
Click To See My Ride 2000 Chevy Silverado LT Z71 K1500 ecsb, 6" suspention lift, 4.56 gaers, 315/75r16 bfg mt, radix supercharger, gibson headers and cat back, trasgo shift kit, aluminum servos, nelson tune
|