[aaron1234]

We perform the swap in Atlanta, GA. starting at $3500.00. If you desire to
attempt it yourself, you will need engine, trans, ecu, wiring harness,
cutting torch, vehicle lift, mig-welder, engine dolly, sawz-all, flat and
angle metal stock and tubing. Additionally, you will need to fabricate the
following custom parts: front engine mount, modified right side frame rail,
transmission mount, upper dogbone mounts, heater pipes, exhaust downpipe,
throttle bracket, air intake pipe, wiring harness adapter, etc. You will
need the following new parts: front mount (pusher) cooling fans, 94-98 GA
trans mount, front sway bar, shifter cable and lever, custom burned ecu to
disable theft deterrent, batery relocation kit, etc. You will need to cut a
notch in the right side frame to clear the s/c idle pulley. It is NOT a job
for the DIY'er. Even most experienced technicians would not be able to
complete it without a fabricator close by.