Quote:
|
Originally Posted by Ducky_Sota
Thanks for the replies, they were a lot more positive than I had been getting from others!  |
Replace the entire shaft! This is NOT a simple job to do in your garage or driveway and can be dangerous. The entire steering knuckle must be frre to pull out and away from the fender well.. This may or may not affect your alignment. Brake lines could be a hazard. A wide variety of tools will be used. Big hammers, pry bars, tie rod end seperators etc...You may lose tarns fluid, you may need to replace a seal....I have done many without the luxury of a vehicle lift. The last one I did, the safety stand collapsed under the vehicle weight, my face was crushed. I lost an eye, a shoulder and still recovering from my last reconstructive surgery. Do NOT use old, fatigued safety stands FROM CHINA and exercise safety.