[cabulldog]

you may need to re program you keyless entry system here is programming instructions you have to use a fused jumper on the data link connector 6 steps to follow 1 turn ignition switch off 2 jumper terminals 8 blk/wht to terminal 4 blk close all doors 3 turn on ignition door locks cycle 4 press and hold lock and unlock buttons on remote hold for about 30 seconds after this locks will cycle again 5 to program more than one remote repeat step four make sure through this whole process you leave key switch on 5 disconnect jumper from data link connector now you turn ignition switch off but not until this point try using your remotes they should work trunk switch dosent affect keyless just trunk button on drivers door