Yes I did follow his install for the most part. I found it easier to completely remove all three bolts from the from anchor after I had removed the adjustment bolt from the rear anchor. When installing the new bars I would install the front anchor on the shop bench then under the truck I was able to align the rear anchor and slide the bar into it. Then there is enough clearance to lift the front of the bar and remount the front anchor. I was able to complete the whole job in about an hour but I had the benefit of air tools. Good luck and do not over tighten the torsion bars!
A totally off topic question can 32x10.50 swampers clear the stock front bumper. I am planning to go to an ARB but I was going to do the tires first. Looking at the truck this afternoon I am concerned about clearance between the tire and the front bumper.