|
Re: Re: Transmission problem
Quote:
|
Originally Posted by Jeremy-WI
Little jon, give this post to your electrical guy:
Need 1 12vdc 30/40 amp relay
all work done under the dash. Bare a spot on one of the red wires(12v constant) and bare a spot on the pink, all wires are part of the ignition switch harness, cut the white wire in two. For the relay post 86 goes to ground, post 85 gets connected to the bared pink wire, post 30 gets connected to the cut white wire running away from the ignition switch, post 87a(if its not on relay just tape up the white wire on the switch side of the cut)to the white wire ignition side, and post 87 gets connected to a 10 amp fuse and then to the bared red wire
If this makes it work, it was your switch and until something else goes wrong with it it won't need replacing. You don't need a new tranny yet
|
With all the trouble to wire up a relay, you could replace the ignition switch in just about the same amount of time.
Although I would say that is a very creative repair
__________________
Why do you never have enough time or money to do the job right the first time, but enough time and money to do it again?
Got all the certifications
25 years ASE Certified Master Technician
GM WCT
Yea..I work at a DEALERSHIP....got a problem with that?
Want to diagnose cars like the Pros? FOR SALE: OTC Perception 2 channel Labscope (badged as a Matco Reality)
This is my personal labscope that I use to diagnose waveforms, like new, comes with leads and training video
PM Me for details
|