disconnect wire from fan, and remove cross member above the radiator, along with plastic shroud. Then you can get to the clips and bolts that hold the plastic frame of the fans to the radiator. remove the two clips at the top. remove the bolts at the side. disconnect the top hose on the right side. the the bolts on the side are screwwed into clips. the clips must be removed. this is very hard to do because they are designed not to come off by accident. there is a small flange on the engine side of the clip that angles down into the bolt hole. if you use your bolt threads to grip it you can help pull it out as you try to pry the clip off. That maybe difficult to understand but the point is, the clip must be removed to pull the fan assembly out and you will need the clips for the new insall so do not break them or loses them. The wireing harnes will have to be removed from the old assembly and transferred to the new one. This was not an easy job but one that can be done by the home mechanic. I do have small hands and think it wold be very hard for someone with large hands. additional items may have to be remove to make room for your tools and hands.
If you need more info from me be sure to write to me directly at my email address because I am finished with this project and am not regularly checking this forum now.
[email protected]