Some people were asking what is needed to do this swap. I found a guy that is putting together a package on HPOA and he has compiled this list:
Full list:
Transmission
Flywheel
Clutch assembly
Slave cylinder
Clutch master cylinder
All lines and dampener from master to slave cylinder
Includes--
-line from master cylinder to dampener
-dampener, bracket and bolts to hold to fender
-rubber line from dampener to adapter on transmission
-adapter and bolt to hold to transmission
line from adapter to slave cylinder
bolt that holds rubber line to adapter(banjo-bolt)
Starter for manual tranny
Drivers side CV shaft and intermediate shaft
Transmission mount and bracket
Speedometer sensor (salvage yard may leave it on the tranny)
Shifter cables, holding clips, clevis pins and cotter pins
Shifter cable bracket for tranny (salvage yard may leave it on the tranny)
Shifter assembly
Shifter boot assembly and shift knob
Clutch pedal assembly
Both switches for clutch
Brake and gas pedal assembly
30 Amp Relay
Manual ECU
Bolts
That might answer some questions. We should start an FAQ sticky.