Hey guys.
Here's what I found at:
http://www.nightrider.com/biketech/faq_ignition_wires.htm
Any other input anyone?
Excessive oil from leaking valve cover draining into spark plug wells and filling up to the bottom seals of extended multi-part plastic spark plug connectors can cause the bottom seals to un-glue themselves from the plastic extension tubes when the connectors are removed. The only real cure for this problem is to replace the leaking valve cover gaskets. Generally, if there is no crazed arcing tracks over the plastic extension tubes, the oil-soaked connectors can be re-used if you are able to re-glue (with RTV silicone adhesive) the detached seals to the end of the plastic extension tubes after the seals and tubes have been thoroughly cleaned with grease removing cleaner (do not soak them in a solvent), and as much as possible of the old RTV is removed. You can also send for new seals if the detached seals are too swollen. Alternatively, you can send the wires to Magnecor for new seals to be re-glued onto the extension tubes — please leave it to us to clean off the oil.