|
just get a clutch kit, and have your flywheel re-finished if at all possible. a clutch kit will come with a new clutch disk, pressure plate, t/o bearing, dummy shaft, and probly even a new pilot bearing. make sure to clean all finger prints off the flywheel with carb cleaner, brake cleaner or starting fluid, and torque the pressure plate down a few turns at a time in a cross pattern so it doesn't warp. there is a tool to remove the pilot bearing but not sure where you'd find it at. i always just found a piece of round stock about the same size of the hole, filled the hole with grease, and then put the rod in the hole and pounded on the shaft. the preasure of the grease pushes the pilot bearing out, and also grease's up the hole real nice for ya
__________________
|