[canisay182]

im not for sure on the color dont remember but all i did was take some extra wire and conect them to both ends of the wire you cut and run it up beside the shift knob up under the dash and across to the switch. now you will have to disconnect the harness from the switch and take a short wire(about an inch) and cross it between two ef the connecters inside the harness cause the headlights will not pop up unless a connection is made you will have to play with it a little bit to figure out which ones they are just connect two and turn on you lights till the headlights work properly. then do the same with the wire you ran up from tranny you will have to play with this to just plug one wire in and go for a drive on a road with little traffic go slow and plug the other end in diff spots also pushing the button until your speedo drops to zero. your tach should still work, mine does maybe magic cause most people say theres dosent hope this helps some.