[Lear546]

OK, I just got done fixing my display on my 99. I was having the same problem. It takes about 3 minuets with a 7mm socket to remove the entire cluster from the truck, after you remove the front of the dash. The front of the dash is removed by pulling with your fingers. It just clips on the face of the dash. One piece from the headlight switch to the a/c ducts above the ash tray. I found that the problem was a cold solder joint at the re-set switch. I just hit the 2 points where the re-set switch is soldered to the pc board. It's been working fine ever since.