[quote=slacker_53]
Quote:
|
Originally Posted by ponchonutty
Guys, he said that he already has power locks. Also, this is the new style Silverado unless it is a 3/4 ton or heavier truck. Anyway, all your connections will be done at the BCM. The BCM is located behind the drivers side of the dash. The plugs on the BCM face towards the rear of the vehicle. The wires will be in the brown plug. They are white and light blue and need a 12v+ trigger to work.
|
Quote:
|
Originally Posted by ponchonutty
Personally, I would drop the unit in the door. Just pull the power window panel loose from the door panel, you can get your lock/unlock wires at the back of the switch (negative polarity) and pull your power off of the power mirror switch (constant positive), drop the unit into the door panel, snap the power window panel back in place, your done! By doing this you can have the unit installed in less than 30 min.
I've done alot of these and have had no problems, with the I.C. Dynamics unit, you will have a total of four wire to attach to the truck.
Easy install!!
-slacker
|
I prefer to go to the BCM at the colum because it is much more weather tight. Plus, you can pick up light flash and horn honk right there so you can have lock and unlock confirmation. I only go inside the doors when people do not want those options and it being difficult to grab the lock/unlock wires anywhere else.