|
I am currently putting a JDM B16A in my 94 hatch back. I am almost done, I have one axle left to put in and fix the exhaust because my downpipe got cut before they shipped it. and wire the car. The only problems i have run into so far is that I had to extend the rear motor mount(the one on the firewall) about 1/2 an inch. I am going to get the wiring done profesionally though. The main reason being that the wiring harness in my car is OBD1 and the wiring harness on the motor is OBD2.
The swap isn't difficult, It just takes time. I've been working on my car every other day after school for about 2 weeks and i'm almost done.
|