I have a 91 chevy 2500, 350 TBI ,
fuel injection. I'm going to rebuild a block and put a
edelbrock TBI manaifold on it and use the stock
Throttle body injection on it and all wiring will be
easy. New cam and lifters and use stock heads that
will be tricked out just a little. I hoping to achieve
about 275+ HP with some good bottom end torque. I have the opportunity to get a 99 chevy vortec block and heads. do you know if an Edelbrock #3704 TBI manifold will fit on this long block and if it will bolt up to my tranny. I want to use the stock TBI set up for ease of use. I have found conflicting info about this casting number , whether it is a 2 or 4 bolt main . Casting Number 10243880...350...95-99...4...Gen.I crate motor, "ZZ4", roller cam, one piece rear seal. this info is from
http://www.charlottecountyspeedwayin...ng_numbers.htm and Mortec shows 2-4 bolt. any help-?
thanks
Ron