|
hi pon or anybody???
My installation wasn't succesfull. I believe i did connected everything good but when I'm programming it, it say it should flash 5 times which means code accepted but it didn't.
here below is the online manual for my prostart:
http://206.47.191.115/assembly.nsf/view-AllPDF/CT3300_ig_en_h120s200v104_000000.pdf/$file/CT-3300_ig_en_h120s200v104_000000.pdf?openelement
for 6 pin main ignition harness--->>>>i connected them all.
for 5 pin secondary harness----->>>>connected them all(tach input was connected to white wire in the ECM.
for 12 pin accesory harness---->>>>I just connected 4 wires:
brown >>>> lock
green >>>> unlock
orange >>> not sure about this but I connected it with the YELLOW wire of 5 pin secondary harness to the parking light wire(12 volts when switch is on.
white >>>> i connected this to where OEM ground wire was, I saw a buch there so I unbolt one of the screw and tied it up and bolted it back with the black ground wire of something.
when it says on the manual "press hoodpin for 4 sec(i did that), the driving light stays on, then I turn the key to "ON", then when the lights shuts I turn the key into OFF,ON, OFF, finally I pressed the lock button twice and there was no blinking goin on. I tried this so many times and still didn't work.
thanks in advance
|