|
you are just getting the terminology kinda mixed up. you can only bridge amps or amp channels. you can then connect the sub to the bridged load by wiring them in parallel or series.
you can wire one sub in parallel, if it is DVC.
and when you bridge two mono amps or two channels of an amp, the load the connected amps see will be lower, say 2 ohms if you bridge two channels. this is because you have two different power sources and the impedance is divided by two. hence why you see the minimum impedance rating of two bridged amps to be 4 when they can take a 2 ohm load when unbridged.
|