|
Ohhh, there's a lot of thing that can go wrong...
- when you just cut a piece from the three and it went airborne and fly across the room to end in your dirt t-shirt pile. Forget it... it's gone !
- When the mask leak... anywhere anytime... it just suck !
- When you break the windshield after weeks of repair to remove the stupid scratch it has when you bought the kit.
- When you prime the surface to the perfection and when you put your color on it, the primer tend to ripple and do that very nasty thing in front of your eyes... then you know you'll have to redo the process all over again.
- When the color is applied and the body virtualy finish and you drop it on the ground.
- When you try to acheive that wet look but fish eye appears.
- When you're almost done with a kit, the only thing to do is window trimming... so you mask, do the trimming part, everything goes alright until you remove the mask to find out it leave a VERY dull, damage paint underneat !!!
- When you try to put the body in place and the only wheel you don't look isn't exactely at the right place... so you try to pop the body in place and "ping"... the wheel is gone... probably in that T-shirt pile !
Beleive me, I can go on and on but that would be missing the point. I just hate when all this happen on the same kit !
But when a good kit is finish... I'm very please with the vision of having my own Enzo in the living room... then it's all worth it ! I forget the pain.
|