|
I'm working on my 97 GA Delco radio and have it apart on the kitchen table! There is a lightbulb behind the display. Mine is in a little plastic carrier that half-turns into the circuit board. This should be a pretty easy fix for you. There are 4 screws holding on the console trim, 2 in the opening below the radio and 2 above the speed and tach. Put your auto transmission into 1 to get the shift lever out of the way, move your tilt steering all the way down, and gently pull on the trim, it has metal clips holding it in. The radio is held in with 3 torx screws but I think you can remove the faceplate without actually removing the radio. if you can slide a knife in behind the plastic retainers, you can pry the faceplace forward. there are 2 retainers on each side. This will give you access to the circuit board and voila! the lightbulb.
|