[stretch32]

I believe the 1993 through 1995 had the same RKE (Remote Keyless Entry) system. Any Jeep dealer should be able to give you the part # for reference. I have listed the part # for my 1993. I recently purchased two remotes from ebay and was going nuts trying to find out how to program them. For giggles my wife asked me for the owners manual. And there it was Page 1-6 the programing instructions.(After racking my brains on the computer for days)(LOL) I remembered seeing your posting, and had to come back to reply. HOPE ALL THIS HELPS!

Steve


Part # 56009031

Instructions on programing:

1. Sit inside the vehicle and close all the doors.

2. Place ignition in the OFF position.

3. Open the driver's door and leave open during programming procedure.

4. Move the mechanical door lock lever to the Lock position.

5. Turn ignition to the RUN Position.

6. Aim the transmitter at the Keyless Entry receiver and press Lock Button.

7. Hold for five seconds until the door locks cycle.

8. Turn ignition OFF within 20 seconds.

9. Check receiver memory by cycling the door locks using the transmitter.


Up to four transmitters may be programmed to each receiver.

Security Alarm System if factory should set with the RKE!